so 239 3D Models

SO-239 cap

Cap off unused antenna connectors to protect them from dust, water and contamination wh...

SO-239 cap

If the thread comes out a little bit to tight you can warm up the cap with a heat gun a...

SO-239 Housing

SO-239 usually come as a wall mount connector. I needed one for my rg-58.

SO-239 cap

If the thread comes out a little bit to tight you can warm up the cap with a heat gun a...

SO-239 Connector

its probably already been done....but as a ham radio op I need to work with chassis mou...

SO-239 cap

Cap off unused antenna connectors to protect them from dust, water and contamination wh...

SO-239 cap

If the thread comes out a little bit to tight you can warm up the cap with a heat gun a...

SO-239 Rafter Mount

This is a combination mount and holder I used for mounting an SO-239 based 1/4 wave ant...

SO-239 sturdy mount

Made this for a 1/4th wave ground plane antenna for GMRS. Realized that one could use t...

SO-239 Female Connectors

SO-239 chassis female connector (4 hole).

coax SO-239 bracket

SO-239 Pole Mount

This will screw on to the end of a painters pole or broom handle, and support an SO-259...

SO-239 GP Antenna

This is a bracket to make a Ground Plane Antenna for VHF or UHF radio's. On the picture...

GoPro to SO-239 mount

This is a mount to put the GoPro on a SO-239 magnetic car mount (antenna mount). You ca...

Antenna mount cap (SO-239)

This is a threaded cap for a SO-239 antenna mount. You can install a O-ring to it if yo...

M28 Panel Mount SO-239

This mount is intended to mount an SO-239 bulkhead connector into a 28mm-30mm panel hol...

Ham Radio SO-239 Cover

This is a simple flexible cover for the SO-239 connetor made with TBU.

Antenna mount cap (SO-239)

This is a threaded cap for a SO-239 antenna mount.You can install a O-ring to it if you...

GoPro to SO-239 mount

This is a mount to put the GoPro on a SO-239 magnetic car mount (antenna mount).You can...

ProjectBox_100x60 SO-239 cut outs

ProjectBox 100x60 with so-239 cut outs

UHF/SO-239 dust cap

Just a simple dust cap with thread. Also fits to N female connnector, as thread is the ...

SO-239 / N-type mount

SO-239 or N-type connector yagi boom mount sample of use look on video

M28 Panel Mount SO-239

This mount is intended to mount an SO-239 bulkhead connector into a 28mm-30mm panel hol...

Antenna mount cap (SO-239)

This is a threaded cap for a SO-239 antenna mount. You can install a O-ring to it if yo...

GoPro to SO-239 mount

This is a mount to put the GoPro on a SO-239 magnetic car mount (antenna mount). You ca...

UHF / SO-239 Barrel insulating mount

Ham Radio Operators may appreciate this: This is a very simple print which I designed b...

UHF / SO-239 Barrel insulating mount

Ham Radio Operators may appreciate this: This is a very simple print which I designed b...

SO-239+PL-259+UHF+Kappe

Verschlusskappe fuer Antennenfuss. Gewinde: 5/8-24UNEF

UHF Connector (SO-239) Jig / Stencil

A quick-to-print template to ease drilling, marking, or mock-up of where to place an SO...

Radio Shack SO-239 Chassis Mount

Radio Shack Brand SO-239 Chassis mount UHF Connector. Normally used for Amateur Radio/C...